7 Configuring NK8000
After you have installed the Danger Management System (DMS) and Composer,
you need to configure the DMS
1
.
Once that is done, you perform the NK8000 configuration procedures to get the
NK822xs communicating with the Danger Management System.
For configuration details, see the DMS8000 Network, Fire & Intrusion Con-
nectivity Configuration Guide (edms #007083).
You should have all hardware installed at the client site (such as control units, all
cables, wiring, and so on) before you perform the procedures in this section.
7.1 Configuration checklist
Verify that you have satisfied the items needed in the first checklist before proceed-
ing to the configuration checklist that follows.
The following abbreviations are used the checklists:
DMS-CG - DMS Network, Fire & Intrusion Connectivity Guide
ICC - Product-specific Installation Function & Configuration Commissioning
Guide
For specific edms number, see “Reference documents” in the “About this
document” section on page 5.
ITEMS NEEDED FOR CONFIGURATION
Danger Management software installed....................................................see ICC
Composer installed............................................................................see DMS-CG
Service PC, with Cat. 5 crossed twisted pair cable (if configuring at client’s site)
NK8000 unit(s)
Product-specific ICC
DMS CG, and SiPass and Video Conn. Guides (if applicable)
CONFIGURING NK8000
Configure the DMS and the NK8000 network with Composer (see ICC, DMS-CG)
Launch NW8202………………………………………………………………….. .......p. 34
Configure the NK822x IP address(es) – via NW8202………………………………p. 37
Install the NK822x, connect subsystems and network to NK822x……………......p. 26
Contact Service Centre to download configuration to the NK822x from remote via
Composer
Test the configuration…………………………………………………………….........p. 40
Install the NW8204 Maintenance Tool (optional)……………………………... .......p. 35
1
Follow product-specific Installation Function & Configuration Commissioning Guide.
To Next Page
Loading...
