Careful attention should be paid to the correct connections of Vac power lines.
Fig. 24 VAC power connection
Wires pass through 20mm (cut-out) holes* at the top of the cabinet (see Fig.
25), and continue behind the cabinet to pass through the rear-side cavity to
the entrance hole (see Fig. 26 and Fig. 27) where they should be anchored
securely before being connected to the screw terminators.
Fig. 25 Top view of NE8000 cabinet
*When entering the metallic frame of the cabinet, wires should be protected by a
self-extinguishing plastic cord guard (UL94-V2 flammability rating).
(Not provided in the supply).
To Next Page
Loading...
