Siemens OpenStage 30 T User Manual

Step by Step
Basic functions
24
Accepting calls via the headset
Prerequisite: A headset is connected.
The phone rings. The
o key flashes.
o Press the key shown.
if nec.
+ or - Set the call volume.
Switching to speakerphone mode
People present in the room can participate in your call.
Prerequisite: You are conducting a call via the handset.
n ] Hold down the key and replace the handset. Then re-
lease the key and proceed with your call.
if nec. + or - Set the call volume.
U.S. mode
If your communication system is set to U.S. mode (con-
tact your service personnel), you do not have to hold
down the speaker key when replacing the handset
when switching to speakerphone mode.
n Press the key shown.
] Replace the handset. Proceed with your call.
if nec. + or - Set the call volume.
The headset port on the phone is preset for a
corded device and is automatically switched
when you use a cordless headset. You must
however use the "call answer" function of the
headset at least once so that the telephone can
make the corresponding setting.

Siemens OpenStage 30 T Specifications

General

Brand	Siemens
Model	OpenStage 30 T
Category	Telephone
Language	English