Siemens POWERMOBIL - Documents Required; Required Tools, Test Equipment and Aids

General 1 - 3
Siemens AG SPR2-240.841.01 Page 3 of 4 POWERMOBIL
Medical Solutions Rev. 01 05.03 CS PS 24
Documents required 1
Required tools, test equipment and aids 1
POWERMOBIL Service Manual SPR2-240.898.01...
POWERMOBIL IQ-Quick Test SPR2-240.820.01...
POWERMOBIL Wiring Diagram G5481
POWERMOBIL - System Manual SPR2-240.802.01...
All tools, test equipment and aids, with the exception of those
marked "*", are listed with specifications in the STC (Service Tool
Catalogue).
• Tool case *
• 1 set of Allen keys * for setting the angulation brake
• 30 mm socket* for disassembling the cable module
• 55 mm socket*
• Ratchet for 30 mm and 55 mm socket*
• Ejector for SUB-D connector pins *
• Ejector for AMP connector pins *
• Bench of approx. 60 cm x 100 cm
(if possible, height-adjustable)
for disassembling / assembling X-ray image inten-
sifier and for temporary storage of the horizontal
carriage
• 200 N spring balance (e.g. 44 15 113 RH090)
• Squared timber * (approx. 60 mm x 70 mm x 100 mm)
• Extractor with 2 clasps* Clasp width approx. 23 cm
• Loctite 221*
• 1 set of resolution tests (e.g. 28 71 820 RE999)
• 1 set of X-ray filters (e.g. 97 98 596 G5321)
• Precision radiation filter 2.1 mm CU (e.g. 99 00 598 XE999)
• 25 mm AL measuring stand, type
26765 acc. to DIN 6868 Part 50*
1.2 mm CU and
17 micrometer CU strips
or
(e.g. from set 97 98 596 G5321)
(e.g. 11 67 662 G5247)
• Centering cross (e.g. 96 60 051 RE999)
• Dynamic test case (e.g. 37 90 156 X1963 or 97 50 001 X1963)
• Torque wrench 3 Nm - 20 Nm (e.g. 34 24 553)
• Digital multimeter (e.g. "Fluke 8060 A", Part No. 97 02 101)
• Ground wire test meter (e.g. "Safety Tester Bender UNIMET 1000 ST",
51 38 727)
• Service PC running WINDOWS 95 operating system*
• Service Software *
• Serial interface cable "Service PC - SIREMOBIL" (e.g. Part No. 99 00 440)
NOTE