Web diagnostics
11.2 Setup and operation
Configuring and commissioning S7 CPs for Industrial Ethernet
170 Configuration Manual, 09/2013, C79000-G8976-C182-13
Access using STEP 7 (STEP 7 V5.5)
Follow the steps outlined below to start Web diagnostics:
1. Connect your PG/PC with the LAN to which the CP is connected.
2. Open the properties dialog of the CP
3. On the "Diagnostics" tab, under "Web Diagnostics", select the interface via which you can
reach the CP.
4. Click the "Web diagnostics" button.
Result: Web diagnostics opens with the "Start Page".
Access using STEP 7 (STEP 7 Professional)
Follow the steps outlined below to start Web diagnostics:
1. Connect your PG/PC with the LAN to which the CP is connected.
2. Select the CP and select "Properties > General > Web diagnostics" in the group of
parameters
3. Select the interface via which you can reach the CP.
4. Click the "Web diagnostics" button.
Result: Web diagnostics opens with the "Start Page".
To Next Page
Loading...
