Siemens S7-300 - Topology - Table View Tab

Web diagnostics
11.3 Diagnostics pages of the CP
Configuring and commissioning S7 CPs for Industrial Ethernet
192 Configuration Manual, 09/2013, C79000-G8976-C182-13
Views after changes to the configuration
● After having failed, this device remains at the same position in the "Target topology" view.
This error state is indicated by means of a device header with red frame and a red
wrench
.
● After having failed, the device is displayed in the bottom area of the in the "Actual
topology" view. This error state is indicated by means of a device header with red frame
and a red wrench.
Link between the "Topology" and "Module information" Web pages
The two web pages, "Topology" and "Module information", are linked. A click on the header
of a selected module in the topology view automatically takes you to this module on the
"Module information" Web page.
See also section "Module status / rack configuration (Page 175)".
11.3.11.2
Topology - "Table view" tab
Meaning
The Web page in the "Table view" tab shows a detailed list of the PROFINET IO
components and their interconnection along with status information.
Parameters
Function
Port
Status The column contains the following symbolic status displays
side-by-side:
1. Status of the PROFINET nodes
2. Module status of the PROFINET nodes
You will find an explanation of the symbols in the tables that
follow.
Name Name of the module specified in the configuration.
By clicking on the name you open the corresponding Web
page "Module information" with the details of the
configuration.
Module status / rack configuration (Page 175)
Module type
Product name
Port
List of the interfaces available on the module.
Partner port
Name
Name of the partner module specified in the configuration.
Port
Port used on the partner module