Siemens S7-300 - Diagnostics Pages of the CP; Start Page

Web diagnostics
11.3 Diagnostics pages of the CP
Configuring and commissioning S7 CPs for Industrial Ethernet
172 Configuration Manual, 09/2013, C79000-G8976-C182-13
③
Navigation area
The navigation area contains the links to the Web pages of Web diagnostics; known below as the diagnostics
pages.
The type of module is displayed in the header line of the navigation area (here: "SIMATIC S7 CP"). If security is
enabled, the login name and the "Logout" button are displayed.
④
Content area
Contains information, parameters and buttons for the function selected in the navigation area. With certain
functions or parameters, extra information is displayed in the lower section of the content area.
When necessary, further function groups can be selected using the individual tabs.
Note
The language file and language setting for Web diagnostics are independent of each other
The language file used for the diagnostics buffer texts is used regardless of the language
setting for Web diagnostics. The loaded language file is therefore valid for all selected
language s
ettings.
Downloading the language file in the update center
(Page 194)
11.3
Diagnostics pages of the CP
Note
Displayed diagnostics pages and parameters - how this depends on the CP type
The diagnostics pages or parameters described below are not all available for every CP
type.
Depending on the CP type, you will find, for example, information on the device as
PROFINET IO controller and/or PROFINE
T IO device in the navigation panel under
"PROFINET IO". If the CP supports various PROFINET IO modes, this depends on the
specific configuration of the device.
11.3.1
Start page
The configured name of the CP is displayed below the title bar of the start page.
"General" tab / contents area
This page displays general device data and the status of the connected CP.
Parameters
Function
General
Station name
Configured name of the station in which the CP is installed.