STEP 7 special diagnostics
12.3 Starting diagnostics
Configuring and commissioning S7 CPs for Industrial Ethernet
208 Configuration Manual, 09/2013, C79000-G8976-C182-13
Figure 12-4 Example of the parameter settings for the online path with multiple gateways
Example - case c: IP subnet gateway via an Advanced CP with 2 interfaces
In the following situation, the CP to be diagnosed is in a different IP subnet from your PG/PC
(but in the same S7 subnet). The IP subnet gateway is on an Advanced CP with 1
PROFINET interface and 1 gigabit interface.
Figure 12-5 Example of a gateway via an Advanced CP
In this case, the CP to be diagnosed is then not accessible if the interface is set to ISO on
your PG/PC. In this case, follow the steps below in HW Config:
To Next Page
Loading...
