Siemens SCALANCE W780

Configuring with Web Based Management
5.4 "Information" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
110 Configuration Manual, 03/2015, C79000-G8976-C267-08
5.4.10
DHCP Server
This page shows whether IPv4 addresses were assigned to the devices by the DHCP
server.
Description
●
IP Address
Shows the IPv4 address assigned to the device.
●
Pool ID
Shows the number of the IPv4 address band.
●
HW Type
Shows that the DHCP server identifies the devices in the network based on the MAC
address.
●
HW Address
Shows the MAC address of the DHCP client.
●
Allocation Method
Show whether the IPv4 address was assigned statically or dynamically. You configure the
static entries in "System > DHCP > Static Leases".
●
Binding State
Shows the status of the assignment.
– assigned
The assignment is used.
– not assigned
The assignment is not used.
– probing
The assignment is being checked.
– unknown
The status of the assignment is unknown.
●
Expire Time
Shows how long the assigned IPv4 address is still valid. Once this period has elapsed,
the device must either request a new IPv4 address or extend the lease time of the
existing IPv4 address.