Siemens SCALANCE W780

Configuring with Web Based Management
5.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08
285
The table has the following columns:
●
Radio
Specifies the WLAN interface to which the settings relate.
●
Port
Specifies the VAP interface to which the settings relate.
●
SSID
Specifies the SSID to which the settings relate.
●
Enable
When enabled, the access restriction is used. You configure which devices are
accessible to the clients in "Security > Inter AP Blocking > Allowed Adresses".
●
Block Gratuitous ARP Request
When enabled, gratuitous ARP packets are not forwarded.
●
Block Non-IP Frames
When enabled, there is no exchange of non-IP packets, for example layer 2 packets
between the client and the devices configured on the access point as permitted
communications partners.
5.9.4.2
Allowed addresses
Note
•
This tab is available only in access point mode.
•
This WBM page can only be configured with the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5 907-8PA00)
–
W700 Security (MLFB 6GK5907-0PA00)
On this page you specify which devices are accessible to the clients.