Configuring with Web Based Management
5.5 "System" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
156 Configuration Manual, 03/2015, C79000-G8976-C267-08
TFTP
Loading and saving data via a TFTP server
On this page, you can configure the TFTP server and the file names. The WBM also allows
you to store device data in an external file on your client PC or to load such data from an
external file from the PC to the devices. This means, for example, that you can also load new
firmware from a file located on your client PC.
Note
Incompatibility with predecessor versions
During the installation of a previou
s version, the configuration data and log files can be lost.
In this case, the device starts up with the factory settings after the firmware has been
installed.
Incompatibility with previous versions with PLUG inserted
During the installation of a previous
version, the configuration data and log files can be lost.
In this case, the device starts up with the factory settings after the firmware has been
installed. In this situation, if a PLUG is inserted in the device, following the restart, this has
the stat
us "Not Accepted" since the PLUG still has the configuration data of the previous
-to-date firmware. This allows you to return to the previous, more up-to-date
firmware without any loss of configuration data.
If the original configuration on the PL
UG is no longer required, the PLUG can be deleted or
rewritten manually using "System > PLUG".
Note
Configuration files and trial mode/Automatic Save mode
In Automatic Save mode, the data is saved automatically before the configuration files
(ConfigPac
k and Config) are transferred.
In Trial mode, although the changes are adopted, they are not saved in the configuration
files (ConfigPack and Config). Use the "Write Startup Config" button on the "System >
Configuration" WBM page to save changes in the con
figuration files.
To Next Page
Loading...
