Configuring with Web Based Management
5.6 "Interfaces" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08
243
The CSV file contains information on the configuration of the device and detailed information
on all individual measurements and is divided into two areas. The first area contains the
configured settings:
● The system name of the client
● The IP address of the device
● The MAC address of the device
● The total number of measured values
● The interval between acquisition of two measured values
● The maximum data rate
● The setting of the external antennas
● The maximum possible transmit power
The second area is a table. The table contains the following for each measured value:
● Sample
The consecutive number of the measurement
● Timestamp
The time stamp
● BSSID
The BSSID
● Signal
The received signal strength in %
● dBm
The received signal strength in dBm
● RSSI
The raw value of the RSSI (Received Signal Strength Indication)
● Roaming
The roaming indicator. The indicator changes between 0 and 1 with each roam
● Channel
The current channel or the channel on which the client is connected to the access point
● HT-40
The channel bandwidth 40 MHz
● Avg. TX-Rate
The average data rate of the sent data packets
● AP System Name
The name of the access point
To Next Page
Loading...
