Installation
3.1 Panel mounting
PAC1020
Equipment Manual, 05/2020, L1V30610008B-01
23
3.1 Panel mounting
You require the following tool for installation:
• Cutting tool for the panel cutout
Additional installation accessories
• Cable clamp for strain relief of the communication cable and the connecting cables at the
digital inputs/outputs.
3.1.1 Mounting dimensions
Mounting and clearance dimensions
You can find information on the cutout dimensions, frame dimensions and clearances in
chapter Dimensional drawings (Page 77).
3.1.2 Installation steps
Installation steps
Proceed as follows to install the power monitoring device in the panel:
Figure 3-2 Installation
< 1 mm or > 2 mm, the use of optionally available mounting adapters
(7KM9900-06A00-0AA0) is recommended.
To Next Page
Loading...
