Siemens SIMATIC CloudConnect CC7 Series - Technical Specifications; Technical Specifications - Cloudconnect 712

SIMATIC CC7
Operating Instructions, 10/2019, C79000-G8976-C503-02
125
Technical specifications
6
6.1 Technical specifications - CloudConnect 712
Technical specifications - CloudConnect 712
Article number
6GK1411-1AC00
Attachment to Industrial Ethernet
Quantity
2 x gigabit interface (P1, P2)
Design
RJ-45 jack, galvanically isolated
Properties
• Standard
• Transmission speeds
• Other properties
• 1000BASE-T, IEEE 802.3ab
• 10 / 100 / 1000 Mbps
• Half duplex/full duplex, autocrossover, autonegotiation, autosensing
Power supply
Design
Socket including 5-pin terminal block with reverse polarity protection
Power supply
• Type of voltage
• Permitted low limit
• Permitted high limit
• 24 V DC
• 19.2 V
• 28.8 V
Terminal block
(Power supply)
Clamping screw M2
Screwdriver blade:
0.4...2.5 (DIN 5264)
Tightening torque
0.2...0.25 Nm
Connectable cable cross-sections
• Without wire end ferrule
• With wire end ferrule
• 0.5...2.5 mm
2
/ AWG 20...12
• 0.5....1.5 mm
2
/ AWG 20 .. 16
Further electrical data
Current consumption (typical)
200 mA
Effective power loss (typical)
4.8 W
Overvoltage category according to
IEC / EN 60664-1
Category II
Permitted ambient conditions
Ambient temperature During operation with the rack in-
stalled horizontally
0 °C ... +60 °C
During operation with the rack in-
stalled vertically
0 °C ... +50 °C
During storage
-40 °C ... +70 °C
During transportation
-40 °C ... +70 °C
Relative humidity
During operation
≤ 60 % at 25 °C, no condensation
Permitted contaminant concentration Corrosive gas test according to ISA-S71.04 severity level G1, G2, G3
• SO
2
• H
2
S
• < 0.5 ppm
• < 0.1 ppm