7.2 Removing a terminal block
Tools required
Screwdriver 3.5 mm:
● For removing the wiring on the terminal block
● For removing the coding element
Removing a terminal block
If no I/O module is connected to a terminal block, you can remove the carrier module from the
terminal block at any time.
Requirement:
The supply voltages are switched off.
Removing a terminal block:
Note
Power bus is disconnected
The current potential group is interrupted if a terminal block is removed.
Removal
7.2 Removing a terminal block
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD 105
To Next Page
Loading...
