6.1.5 Applying reference identification labels
Procedure
Proceed as follows to apply a reference identification label:
1. Break off the reference identification labels from the sheet.
2. Insert the reference identification labels into the insert opening on the top of the modules:
– Interface module
– BusAdapter
– I/O module
– Slot cover
① Reference identification labels
② Opening for label
Figure 6-3 Applying reference identification labels
Wiring
6.1 Markings of IO device components
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD 79
To Next Page
Loading...
