7.6 Removing the carrier module for the interface module
Tools required
Screwdriver 4.5 mm or TORX T15 (recommended): For loosening the fixing screws for the rail.
Initial situation
The IO device is wired. There are additional components (carrier modules and I/O modules) to
the right of interface module.
Requirement
● The supply voltages for this IO device are shut off.
● All adjacent components to the right (carrier modules or server module) have been
removed.
You can find information on this in the following sections:
– Section "Removing a server module and power bus cover (Page 103)"
– Section "Removing a terminal block (Page 105)"
– Section "Removing the carrier module (Page 108)"
– Section "Removing the interface module (Page 111)"
● There must be at least 8 mm of clearance to adjacent carrier modules.
Removal
7.6 Removing the carrier module for the interface module
ET 200SP HA Distributed I/O system
112 System Manual, 08/2019, A5E39261167-AD
To Next Page
Loading...
