Siemens SIMATIC ET 200SP HA - Applying Labeling Strips

Applying color-coded labels
Press the color-coded labels into the terminal box of the terminal block.
&&
&&
&&&&&&
Figure 6-2 Applying color-coded labels
Additional information
● Module-specific color-coded labels (22.5 mm) for the process terminals (see manual I/O
module (
http://www.siemens.com/pcs7-documentation))
● Ordering information (see section "Accessories/spare parts (Page 171)"; "Table B-2
Accessories, color-coded labels for I/O modules (Page 172)")
6.1.4 Applying labeling strips
Procedure
Proceed as follows to install a labeling strip:
1. Label the strips.
2. Insert the labeling strip into the interface module or I/O module.
Wiring
6.1 Markings of IO device components
ET 200SP HA Distributed I/O system
78 System Manual, 08/2019, A5E39261167-AD