8.7 Removing wires
Procedure
Adhere to the following sequence:
Step Procedure Illustration
1 Press the screwdriver into the spring release of the
terminal as far as it will go.
● The terminal opens.
Leave the screwdriver in the spring release.
2 Pull out the cable.
Note
Avoid damaging the terminal
Never pull on the wire/cable while pressing the spring release.
Maintenance
8.7 Removing wires
ET 200SP HA Distributed I/O system
128 System Manual, 08/2019, A5E39261167-AD
To Next Page
Loading...
