Procedure
Step Procedure Illustration
1
1. Use the screwdriver to pull the interlocks (①
and ②) out of the carrier module up to the
latching point of the carrier module.
2. Loosen the fixing screws ③ for the rail on the
carrier module.
2 Move the carrier module parallel to the right by at
least 8 mm.
3
1. Swivel the carrier module out of the rail ④.
2. Lift the carrier module up off the rail ⑤.
Removal
7.3 Removing the carrier module
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD 109
To Next Page
Loading...
