Required accessories
You can use the following screw types for fastening the rails:
Table 5-2 Required accessories
For ... you can use ... Explanation
outer fixing screws M6 cylinder head screw
according to ISO 1207/
ISO 1580 (DIN 84/DIN 85)
Choose a suitable screw length for your
assembly.
You also need washers for cylinder head
screws with an internal diameter of
6.4 mm and an external diameter of
11 mm in accordance with ISO 7092
(DIN 433).
Additional mounting screws
(for mounting rails
> 482.6 mm)
M6 hexagonal head screw
according to ISO 4017
(DIN 4017)
Dimensions for the drill holes
Table 5-3 Dimensions for the drill holes
Rails
a = Length of the rail 482.6 mm 1500 mm (> 530 mm)
b 65 mm
c 155 mm
d 8.3 mm 15 mm
e 466 mm See x
f 10.2 mm 10.2 mm (for information on additional drill holes,
see the following paragraph)
x Not available Recommended distance between 2 mounting
points max. 500 mm
Installation
5.3 Installing the rail
ET 200SP HA Distributed I/O system
62 System Manual, 08/2019, A5E39261167-AD
To Next Page
Loading...
