Procedure
To install this module, proceed as follows: (installation always from left to right)
Note
Recommendation
Install all carrier modules one after the other before you begin installing the terminal blocks.
Step Procedure Illustration
1
1. Hang the carrier module
(for setting up the modular
slots) on the rail.
Adhere to the maximum
configuration length;
section "Hardware
configuration (Page 28)".
2. Swivel the carrier module
backwards on the rail.
2 Ensure that the interlocks (①
and ②) of the carrier module
have been removed.
3 Push the carrier module side‐
ways to the left until it meets
the previous component (car‐
rier module of the interface
module or carrier module for I/
O modules).
4 Ensure that the transport lock
under the fixing screws is re‐
moved.
Installation
5.5 Mounting an carrier module for I/O module slots
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD 69
To Next Page
Loading...
