Procedure
To install these modules, proceed as follows:
(installation always from left to right)
Step Procedure Illustration
1 Slide the terminal block diagonally into the holder of the
carrier module.
2 Swivel the terminal block downwards until the fastening
elements on the carrier module click into place.
(See figure "Fastening the terminal block")
You can find information on wiring in following sections:
● Wiring rules (Page 85)
● Wiring the terminal block (Page 86)
Installation
5.6 Installing the terminal block
ET 200SP HA Distributed I/O system
72 System Manual, 08/2019, A5E39261167-AD
To Next Page
Loading...
