Connecting conductors
Follow these steps
Conductor
(type)
Solid Multi-core (stranded wire)
Mounting Without ferrule With ferrule or ultrasonic compression Without ferrule, unprocessed
Step 1 Strip 8 to 10 mm of the wires.
Step 2 - Compress or crimp the cable with ferrules -
Step 3 - Press the screwdriver into the
spring release.
Step 4 Insert the wire into the push-in terminal as far as it will go.
Step 5 - Pull the screwdriver out of the
spring release.
Step 6 Push the wired connector plug into the socket in the interface module.
Removing a wire
Using the screwdriver, press the spring release as far as it will go and pull out the wire.
Wiring
6.7 Connecting the power supply to the interface module
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD 95
To Next Page
Loading...
