A data transfer point is prescribed for connection to the WAN (Wide Area Network) that
guarantees this degree of safety.
Tools required
Screwdriver 3.5 mm or TORX T10 (recommended):
Mounting the bus connector
Connect the PROFINET cable to the BusAdapter.
Required accessories and installation
You can find additional information on this in the documentation
Industrial Ethernet /
PROFINET Passive network components.
You can find this documentation on the Internet at http://support.industry.siemens.com/cs/ww/
en/view/84922825 (https://support.industry.siemens.com/cs/ww/en/view/84922825)
.
Requirement
The PROFINET connection cables are connected to the BusAdapter (e.g. BusAdapter with
FastConnect cable) or can be retrofitted (e.g. BusAdapter for RJ45 connectors or LC
connectors).
Procedure
Note
Basic representation
The following illustrations show the basic representations using the ET 200SP HA as an
example.
Wiring
6.8 Connecting interfaces for communication
ET 200SP HA Distributed I/O system
98 System Manual, 08/2019, A5E39261167-AD
To Next Page
Loading...
