Siemens SIMATIC Ident RF200 - RESET Command

Command and message frames
2.9 "RESET" command
ASCII protocol for RF200
18 Operating Manual, 11/2016, C79000-G8976-C329-04
Address
Designation
Value
Description
Byte 8
Parity
0x30
0x30 ≙ odd parity
0x31 ≙ odd parity
0x32 ≙ no parity
Byte 9 0x30 / 0x31 / 0x32
Byte 10 Stop bit 0x30 0x30 ≙ 1 stop bit
0x31 ≙ 2 stop bits
Byte 11
0x30 / 0x31
Table 2- 15 "SET-RS232" acknowledgment
Address
Designation
Value
Description
Byte 0
Frame length
0x30
Net data length of the frame - 1
byte
Byte 1
0x32
Byte 2
Command
0x42
--
Byte 3
0x42
Byte 4
Status
high nibble
Error code "error_Moby"
Byte 5
low nibble
2.9
"RESET" command
Table 2- 16 "RESET" command
Address
Designation
Value
Description
Byte 0
Frame length
0x30
Net data length of the frame - 1
byte
Byte 1
0x41
Byte 2
Command
0x30
--
Byte 3
0x30
Byte 4
Status
0x30
--
Byte 5
0x30
Byte 6
ScanningTime
0x30
Reserved
Byte 7
0x30
Byte 8 Param
0x30
Operating mode without presence
0x32
Operating mode with presence
0x38 Operating mode without pres. with
antenna control
Byte 9
0x35
Single tag mode
Byte 10
Option1
0x30
0x30 ≙ red LED is not reset
0x32 ≙ red LED is reset
Byte 11
0x30 / 0x32
Byte 12
Dili
0x30
Reserved
Byte 13
0x30