Siemens SIMATIC Ident RF200 - 4 Reader; Ordering Data; LED Status Indicator

ASCII protocol for RF200
Operating Manual, 11/2016, C79000-G8976-C329-04
33
Reader
4
4.1
Ordering data
Table 4- 1 Ordering data of the reader
Article number
RF240R with RS-232 interface (ASCII) 6GT2821-4AC40
RF250R with RS-232 interface (ASCII)
6GT2821-5AC40
RF260R with RS-232 interface (ASCII)
6GT2821-6AC40
4.2
LED status indicator
The LEDs indicate the reader’s operating states. The LED can appear green, red, or yellow
and indicate off
, on , and flashing status:
Table 4- 2 LED status indicator on the reader
Color
Description
Operating voltage present, reader not initialized or antenna turned off
Operating voltage present, reader initialized and antenna turned on
1)
Transponder present
“Command execution active” when operating without presence
Error has occurred, the type of flashing corresponds to the error code in the
table in the section “Error messages”. The optical error display is only reset if
the corresponding reset parameter (“option_1”, see FC 45 / FB 45 documenta-
tion, section “Input parameters”) is set.
No operating voltage present, no startup is possible
RS-232: Parameter in flash undefined (only with the ASCII variant)
1)
Only in the “with presence” mode.