Siemens SIMATIC Industrial Flat Panel IFP1500

Commissioning the device
4.2 SIMATIC IPC Wizard
Industrial Flat Panel IFP1500, IFP1900, IFP2200
Operating Instructions, 06/2014, A5E31298376-AB
51
Note
Using a uniform display type
The combination of single touch and multi
-touch devices is not supported by the SIMATIC
IPC Wizard.
Drivers and applications can
cause malfunctions with mixed operation.
Note for Industrial Flat Panels
•
If you use a SIMATIC Industrial Flat Panel with the PC, connect the Industrial Flat Panel
to the PC before first commissioning.
•
During first commissioning only one Industrial Flat Panel may be connected to the PC.
•
After completion of first commissioning, you can connect another Industrial Flat Panel to
the PC.
Supported operating systems
SIMATIC IPC Wizard can run on SIMATIC Industrial PCs with the following operating
systems:
Display
Operating system
Windows 7 Ultimate
(32/64-bit)
Windows Embedded
Standard 7 P (32/64-bit)
Windows Embedded
Standard 7 E (32/64-bit)
Devices with resistive
single touch screen
x x x
Devices with capacitive
multi-touch screen
x x (in planning)
You need administrator rights for the installation.
Software requirements
● One of the operating systems named in "Supported operating systems" section is
installed.
● The driver for the graphics adapter is installed.
● The installed graphics driver supports reading of EDID data.
Note
If you install a Microsoft operating system without the matching graphics drivers for the
graphics card, the Microsoft operating system installs the VE
SA graphics driver by default.
The Microsoft VESA driver is not supported by the SIMATIC IPC Wizard.