Siemens SIMATIC Industrial Flat Panel IFP1500

Industrial Flat Panel IFP1500, IFP1900, IFP2200
Operating Instructions, 06/2014, A5E31298376-AB
71
Technical information
7
7.1
Certificates and approvals
Note
Approvals on the rating plate
The following overview provides information on possible approvals.
Only the approvals on the
rating plate (Page 83) of the specific device apply.
CE marking
The devices meet the general and safety-related requirements of the following EC directives
and conform to the harmonized European standards (EN) for these devices published in the
official gazettes of the European Community:
● 2006/95/EC "Electrical equipment for use within specific voltage limits" (Low-Voltage
Directive)
● 2004/108/EC "Electromagnetic Compatibility" (EMC Directive)
● 94/9/EC "Devices and protection systems for use as prescribed in
potentially explosive areas" (Guidelines for Explosion Protection)
EC Declaration of Conformity
The EC Declarations of Conformity are available to the relevant authorities at the following
address:
Siemens Aktiengesellschaft
Industry Sector
I IA AS FA WF AMB
PO Box 1963
D-92209 Amberg, Germany
You can download information on the EC Declaration of Conformity, here under the keyword
"Declaration of Conformity":
Certificate Industrial Flat Panel
(http://support.automation.siemens.com/WW/view/en/60242448/134200).
Software license agreements
If the device is supplied with preinstalled software, you must observe the corresponding
license agreements.