Siemens Simatic IPC647C - Installing the Burner Software; Installing Updates; Updating the Operating System; Installing or Updating Application Programs and Drivers

Service and maintenance
11.2 Reinstalling the software
SIMATIC IPC647C
118 Operating Instructions, 12/2010, A5E02669337-02
11.2.8 Installing the burner software
You can find information on installing the burner software on the supplied CD and in the
section
7DVD burner (Page 344).
11.2.9 Installing updates
11.2.9.1 Updating the operating system
Windows
The latest updates for Windows operating systems are available on the Internet at:
Microsoft Side Guide (
7http://www.microsoft.com)
NOTICE
Before you install new drivers or operating system updates for Windows MUI versions, set
the default language to US English in the regional settings for menus and dialogs.
Other operating systems
Contact the corresponding manufacturer.
11.2.9.2 Installing or updating application programs and drivers
Install and connect an appropriate drive in order to install software from a CD and / or floppy
disk in Windows XP Professional.
The USB floppy disk and CD-ROM drivers are included in Windows and do not have to be
installed from other sources.
For information about installation of SIMATIC software packages, refer to the corresponding
manufacturer documentation.
Contact the manufacturer to obtain updates of drivers and application programs you
purchased from third-party vendors.
NOTICE
Before you install new drivers or operating system updates for Windows MUI versions, set
the default language to US English in the regional settings for menus and dialogs.