Configuring
6.3 Configuration via XML
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 04/2020, C79000-G8976-C512-03
59
Description of block commands
You can find a description of the block-specific commands in the respective block manuals:
● FB 45 for RF200, RF300
● RFID standard profile; standard function for RFID systems
● Ident profile and Ident blocks, standard function for Ident systems
6.3 Configuration via XML
This section is intended only for XML users.
Configuration of the communication module is not necessary for pure XML work. You can
continue directly with configuration via WBM and with programming via XML. You can find
detailed information on the XML diagnostic functions in the "XML programming for SIMATIC
Ident (https://support.industry.siemens.com/cs/ww/en/ps/14971/man)" manual.
6.4 Configuration via OPC UA
This section is intended only for OPC UA users.
Configuration of the communication module is not necessary for pure OPC UA work. You
can continue directly with configuration via WBM and with programming via OPC UA.
To Next Page
Loading...
