Siemens SIMATIC S5 Series User Manual

4
4-4
Working with S5-DOS/ST
C79000-G8576-C760-03
The PG is switched off.
PG - PLC Connection with connecting cable (4) direct or via (3),
(7) or (8):
The connectors on the connecting cable (3) with the order no.
6ES5 731-6AG00 are labelled with “PG 7xx COM 1” and
“PLC-S5”.
1. Plug the connector labelled “PG 7xx COM 1” into the COM 1
port of the PG.
2. Plug the other end of the connecting cable labelled “PLC-S5”
into the matching end of the connecting cable (7) or (8) leading
to the PLC.
It is impossible to mix up the connectors on this cable because
they are of different types.
3. Connect the PLC to the remaining free connector.
Screw or clip the connectors in place for safety.
Connecting cable (3), order no. 6ES5 731-6AG00
Connecting cable (4), order no. 6ES5 734-2xxx0
1)
Connecting cable (7), order no. 6ES5 731-0xxx0
1)
Connecting cable (8), order no. 6ES5 731-1xxx0
1)
1)
xxx is the length key. The cables are available in lengths ranging from 1 m to
1000 m. Please refer to the Programmers catalog ST 59 for details on the length
key.
Connecting a PG
with an Active TTY
Port to a PLC
Connecting Cables
for a PG with an
Active TTY Port
Installing Hardware

Siemens SIMATIC S5 Series Specifications

General

Series	SIMATIC S5
Manufacturer	Siemens
Category	Controller
Programming Language	STEP 5
Modular Design	Yes
Power Supply	24V DC
Communication Interfaces	RS-232, RS-485
Memory Type	EPROM, RAM
Digital Inputs/Outputs	Varies depending on module configuration
Analog Inputs/Outputs	Varies depending on module configuration
CPU Type	Varies by model
Memory	Varies by model
Operating Temperature	0°C to 60°C