Siemens SIMATIC S5 Series User Manual

4
4-6
Working with S5-DOS/ST
C79000-G8576-C760-03
The PG is switched off.
PG - PLC Connection with connecting cable (6) direct or via (5),
(7) or (8):
The V.24/TTY converter (Köster box) is configured as described in
Chapter 8 V.24/TTY Converter (Köster box).
1. Establish the connection between the COM 1 port of the PG
and the Köster box using the connecting cable (5).
2. Plug the connecting cable (7) or (8) into the 25-pin socket on
the Köster box and establish the connection to the PLC.
3. Screw or clip the connectors in place for safety.
Connecting cable (5), order no. Köster 224 22x
2)
Connecting cable (6), order no. 6ES5 734-1BD20 (length 3.2m)
Connecting cable (7), order no. 6ES5 731-0xxx0
1)
Connecting cable (8), order no. 6ES5 731-1xxx0
1)
1)
xxx is the length key. The cables are available in lengths ranging from 1m to
1000 m. Please refer to the Programmers catalog ST 59 for details on the length
key.
2)
x stands for the connector type of the PG - Köster box connecting cable
(see Chapter 8, page 0-2).
Connecting a PG
with a V.24 Port to
a PLC
Connecting Cables
for a PG with a
V.24 Port
Installing Hardware

Siemens SIMATIC S5 Series Specifications

General

Series	SIMATIC S5
Manufacturer	Siemens
Category	Controller
Programming Language	STEP 5
Modular Design	Yes
Power Supply	24V DC
Communication Interfaces	RS-232, RS-485
Memory Type	EPROM, RAM
Digital Inputs/Outputs	Varies depending on module configuration
Analog Inputs/Outputs	Varies depending on module configuration
CPU Type	Varies by model
Memory	Varies by model
Operating Temperature	0°C to 60°C