03/2013 3 Setting up functions
3.1 Maintenance
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-101
Function Description Type
Note:
Except for bit variables, all variable formats can
be changed.
Data source For example
• PLC
Address is interpreted in S7 syntax.
• NC
Address in the syntax of the NC interface.
(DocOnCD/DocOnWeb - List Manual 2 or NC
Varselector toolbox - help for OPI variables).
• SINAMICS:
Address defined in SINAMICS for a variable.
• Generic
address for any OPC expression, which is
supported by a driver/server.
• User-defined variable
Address expression that was defined in
SINUMERIK Integrate for a variable.
DISPLAY
SELECTION
Data type Interpretation of the variable value in permissible
S7 syntax.
In addition to the S7 data types, there is the block
type for data of all the variables specified in the
address. If inputs, outputs or bit memory are to be
recorded in the block, the generic type must be
selected.
A graphic display of a block in a diagram is not
possible.
Note
:
The type can always be matched to the variable
and modified within the permissible formats.
DISPLAY
SELECTION
Unit Unit of the variables to be recorded. DISPLAY
INPUT
Conversion
• Output:
Input of 2 values for the real variable value.
• Converted:
Specification for the related dimensioned
values.
DISPLAY
INPUT
(max. 32
digits)
To Next Page
Loading...
