03/2013 3 Setting up functions
3.1 Maintenance
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-99
Add variables by selecting them from predefined variables:
Function Description Type
Axis The variables that can be selected refer to one
axis each. This axis is defined with this selection
field.
DISPLAY
SELECTION
Select all All variables that are available are selected. SELECTION
Add The selected variables are added to the
configuration of the variable monitor.
ACTION
Select NC variables
Changeover in the variable tree between
predefined variables.
The variables are described in detail in the
SINUMERIK documentation.
Function
Select user-defined variables
Changeover in the variable tree between
predefined variables.
Constant:
The constant is always 1 and is used to check the
variable monitors.
Start time:
The start time is the time stamp as of which
variables can be recorded (client runs on the
frontend PC).
Current time:
The current time is the time stamp of the frontend
PC at the time of recording via the variable
monitor.
To Next Page
Loading...
