Need help?Do you have a question about the Siemens SIMOCODE pro V and is the answer not in the manual?
General| Protection degree | IP20 |
|---|---|
| Application | Industrial applications, including water pumps |
| Functionality | Motor control, monitoring, and protection |
| Communication | PROFIBUS DP, PROFINET, Modbus RTU |
| Protection functions | Overload, phase failure |
| Control functions | Direct, reversing, star-delta, soft starter |
| Monitoring functions | Current, voltage, power, energy, temperature, operating hours |
| Diagnostics | Fault messages, alarm messages |
| Parameterization | SIMOCODE ES software |
| Current range | 0.3 A to 820 A (depending on the device) |
| Voltage range | 24 V DC to 690 V AC |
| Analog outputs | Up to 2 (depending on model) |
| Mounting | DIN rail or screw mounting |
| Approvals | CE, UL, CSA, ATEX |
| Rated operational voltage | 24 V DC to 690 V AC |
| Rated operational current | 0.3 ... 820 A |
| Ambient temperature range | -25 °C to +60 °C (depending on the device) |
| Device type | Motor management and protection system |
Describes logic blocks like truth tables, counters, timers, and limit monitors.
Explains how motor current and power factor detect flow disturbances.
Details switching, shut-off, and manual reversal commands.
Covers fault shutdown, restart procedures, and fault counter reset.
Details the physical setup of the SIMOCODE system components.
Guides on component installation, wiring, and initial setup.
Configuration of PROFINET, IP, device, motor, and logic parameters.
To Next Page