Siemens SIMOCODE pro V - Table of Contents

Table of contents
Blocking Protection for Pumps with SIMOCODE pro V
Article ID: 109478058, V2.0, 09/2020
3
© Siemens AG
2020 All rights reserved
Table of contents
Legal information ......................................................................................................... 2
1 Introduction ........................................................................................................ 4
1.1 Overview............................................................................................... 4
1.2 Delimitation ........................................................................................... 5
1.3 Required knowledge ............................................................................. 5
1.4 Components used ................................................................................ 6
2 Operating principle ............................................................................................ 9
2.1 Logic blocks in use ............................................................................. 10
2.2 Explanation of the logic ...................................................................... 12
2.2.1 Embedding ......................................................................................... 12
2.2.2 Detecting faults in the conveying flow ................................................ 13
2.2.3 Switching on via the control station .................................................... 14
2.2.4 Shutting off via the control station or in the event of a fault ............... 15
2.2.5 Manual reversal in the other direction of rotation ............................... 16
2.2.6 Reversal in the opposite direction when conveying fault has
been detected ..................................................................................... 17
2.2.7 Fault shutdown after defined number of reversals ............................. 17
2.2.8 Drive start after fault shutdown .......................................................... 17
2.2.9 Resetting the fault counter during operation ...................................... 18
2.2.10 Blockage in the opposite direction ..................................................... 18
2.2.11 Cyclic communication with the controller ........................................... 18
3 Engineering ...................................................................................................... 20
3.1 Hardware configuration ...................................................................... 20
3.1.1 Basic unit (BU) ................................................................................... 21
3.1.2 Detecting irregularities in the conveying flow ..................................... 21
3.1.3 Clearing blockages in the conveying flow .......................................... 21
3.1.4 Digital module (DM) ............................................................................ 21
3.1.5 Operator panel (OP) ........................................................................... 21
3.1.6 Communication with a PLC ................................................................ 21
3.2 Installation and commissioning .......................................................... 22
3.2.1 Hardware installation .......................................................................... 22
3.2.2 Installing the software ......................................................................... 23
3.2.3 Downloading configuration and parameterization to the
SIMOCODE pro V PN basic unit ........................................................ 24
3.2.4 Commissioning ................................................................................... 27
3.3 Parameterization ................................................................................ 28
3.3.1 Creating the hardware configuration .................................................. 29
3.3.2 Parameter assignment for the SIMOCODE pro V PN ....................... 31
3.3.3 Compile parameterization .................................................................. 53
3.4 Operation ............................................................................................ 54
3.4.1 General remarks on Monitoring and Control ...................................... 54
3.4.2 Scenarios ........................................................................................... 59
4 Useful information ........................................................................................... 62
4.1 Time stamping .................................................................................... 62
5 Appendix .......................................................................................................... 63
5.1 Service and support ........................................................................... 63
5.2 Links and literature ............................................................................. 64
5.3 Change documentation ...................................................................... 64