Blocking Protection for Pumps with SIMOCODE pro V
Article ID: 109478058, V2.0, 09/2020
© Siemens AG
2020 All rights reserved
8. Follow the notes and instructions on the screen during the download process.
9. A successful download will appear as follows.
The download process will be aborted with an error if the SIMOCODE device is
in the "Remote/Automatic" operating mode, if an "ON" command is pending, or if
the motor is running.
3.2.4 Commissioning
A specific commissioning sequence is not required. If you have carried out the
hardware and software installation described above, you only have to connect the
power circuit with the 3-phase mains or switch on the SIRIUS circuit breaker.
For information on operating the application example, refer to chapter 3.4.
To Next Page
Loading...
