Siemens SINAMICS G120P Manual

3 Setting up and commissioning the application
3.5 Loading the software
SINAMICS G120 DP at S7-1200
Entry-ID: 70155469, V1.4, 07/2018
15
Copyright  Siemens AG 2018 All rights reserved
No.
Action
Remarks
13.
If the used SINAMICS drive has a
safety configuration, please also
reset it.
1. In “Restore factory setting”
you choose the “Safety
parameters will be reset”
option.
2. Start the function.
3. Enter the previous Safety
password.
4. Confirm with OK.
14.
1. Disconnect the online
connection to SINAMICS
drive.
2. Saving the data to EEPROM
is not necessary at present.
15.
Load the drive configuration into
the SINAMICS G120.
1
2
3
4
All Safety parameters will be reset
1
2

Siemens SINAMICS G120P Specifications

General

Frequency Range	0 Hz to 550 Hz
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Relative Humidity	5% to 95% (non-condensing)
Voltage Range	200 V to 240 V, 380 V to 480 V, 500 V to 690 V
Output Voltage	0V to input voltage
Control Type	Vector control, V/f control
Protection Class	IP20, IP55
Communication Interfaces	PROFIBUS, PROFINET, Modbus RTU
Cooling Method	Air cooling
Altitude	Up to 2000 m without derating
Power Range	0.37 to 630 kW