Siemens SINAMICS G120P Manual

4 Operating the Application
4.3 Monitoring and parameter access via operator panel
SINAMICS G120 DP at S7-1200
Entry-ID: 70155469, V1.4, 07/2018
25
Copyright  Siemens AG 2018 All rights reserved
4.3.3 Parameter access
Reading/writing parameters
Figure 4-6: Reading/writing parameters
Table 4-3: Instructions – writing/reading parameters
Action
Remark
1.
Select the access type with the
“Read parameters” and “Write
parameters” buttons.
The selected access type is displayed via
a bright green button.
2.
Read parameters:
Proceed with point 3 in the table.
Write parameters:
When tapping or clicking the yellow
input fields for the ramp-up/ramp-
down time, a keyboard mask for the
value input opens. Finish your input
with the Return key.
8,0
Ramp up time
Ramp down time

Siemens SINAMICS G120P Specifications

General

Frequency Range	0 Hz to 550 Hz
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Relative Humidity	5% to 95% (non-condensing)
Voltage Range	200 V to 240 V, 380 V to 480 V, 500 V to 690 V
Output Voltage	0V to input voltage
Control Type	Vector control, V/f control
Protection Class	IP20, IP55
Communication Interfaces	PROFIBUS, PROFINET, Modbus RTU
Cooling Method	Air cooling
Altitude	Up to 2000 m without derating
Power Range	0.37 to 630 kW