Commissioning via the built-in BOP
5.6 Function commissioning
SINAMICS V20 Converter
112 Operating Instructions, 10/2019, A5E34559884-012
Function diagram
Description:
The hammer start mode is enabled when an ON command is issued, and the following
sequence is performed:
● Ramp up to P3354 Hz with the boost level specified by P1310, P1311, and P1312
● Revert boost level to that specified by P1310, P1311, and P1312
● Revert to "normal" setpoint and allow output to ramp using P1120
To Next Page
Loading...
