Commissioning via the SINAMICS V20 Smart Access
6.8 Setting parameters
SINAMICS V20 Converter
158 Operating Instructions, 10/2019, A5E34559884-012
Specifying user-defined parameters
User-defined parameters are stored in "My parameters" group. The common parameters
(Page 79)are already added to this parameter group as factory default settings. If you desire
to define certain parameters (including any specific indexed parameters) in a target group to
be user-defined parameters, proceed as the example given below:
All successfully defined parameters will go to "My parameters" group. Proceed as follows to
view these parameters:
To Next Page
Loading...
