Siemens SINAMICS V20

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
235
Parameter
Function
Range
Factory
default
Can be
changed
Scaling
Data
set
Data
type
Acc.
Level
P0802
Transfer data from
EEPROM
0 - 2 0 C(30) - - U16 3
Transfers values from the converter to external device when P0802 ≠ 0. P0010 must be set to 30 for this
to be possible.
0
Disabled
2
Start data transfer to the SD card
Note:
Parameter is automatically reset to 0 (default) after transfer.
P0010 will be reset to 0 on successful completion.
Ensure that enough space exists on the SD card before transferring data (8 KB).
P0803
Transfer data to
EEPROM
0 - 3 0 C(30) - - U16 3
0
Disabled
2
Start data transfer from the SD card
3
Start data transfer from the SD card (except the motor data)
Transfers parameter values from the SD clone file to the converter when P0803 ≠ 0. P0010 must be set to
30 to activate this parameter. See P0802 for parameter values.
Note:
Parameter is automatically reset to 0 (default) after transfer.
P0010 will be reset to 0 on successful completion.
P0804
Select Clone file
0 - 99
0
C(30)
-
-
U16
3
Select clone file to upload/download.
if P0804 = 0, then the file name is clone00.bin
if P0804 = 1, then the file name is clone01.bin
etc.
P0806
BI: Inhibit panel access
0 - 4294967295
0
U, T
-
-
U32
3
Binector input to lock control panel access through external client.
r0807.0
BO: Displays client ac-
cess
- - - - - U16 3
Binector output to display whether command and setpoint source is connected to an external client.
Bit
Signal name
1 signal
0 signal
00
Master control active
Yes
No
P0809[0...2]
Copy command data set
(CDS)
0 - 2 [0] 0 [1] 1
[2] 0
T - - U16 2
Calls 'Copy command data set (CDS)' function. The list of all command data sets (CDS) parameters is
shown in "Index" at the end of the manual.
Example:
Copying of all values from CDS0 to CDS2 can be accomplished by the following procedure:
P0809[0] = 0 Copy from CDS0
P0809[1] = 2 Copy to CDS2
P0809[2] = 1 Start copy
Index:
[0]
Copy from CDS
[1]
Copy to CDS
[2]
Start copy
Note:
Start value in index 2 is automatically reset to '0' after execution of function.