Siemens SINAMICS V20

Parameter list
8.2 Parameter list
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
243
Parameter
Function
Range
Factory
default
Can be
changed
Scaling
Data
set
Data
type
Acc.
Level
Note:
All values in RAM are transferred to EEPROM.
Parameter is automatically reset to 0 (default) after successful transfer.
The storage from RAM to EEPROM is accomplished via P0971. The communications are reset, if the
transfer was successful. During the reset process communications will be interrupted.
• BOP displays 88888
After completion of the transfer process, the communication between the converter and external periph-
erals (BOP, USS or Modbus Master) is automatically re-established.
r0980[0...99]
List of available parame-
ter numbers
0 - 65535 981 - - - U16 4
Contains 100 parameter numbers index 0 - 99.
Index:
[0]
Parameter 1
[1]
Parameter 2
...
...
[98]
Parameter 99
[99]
Next parameter list
Note:
The parameter list array has 2 elements to reduce memory consumption. On each access to an element
index 0 - 99, the individual result is determined dynamically by the 'BeforeAccess' function. The last ele-
ment contains the number of the following parameter array, 0 indicates end of list.
r0981[0...99]
List of available parame-
ter numbers
0 - 65535 982 - - - U16 4
Contains 100 parameter numbers index 100 - 199.
Index:
See r0980
Note:
See r0980
r0982[0...99]
List of available parame-
ter numbers
0 - 65535 983 - - - U16 4
Contains 100 parameter numbers index 200 - 299.
Index:
See r0980
Note:
See r0980
r0983[0...99]
List of available parame-
ter numbers
0 - 65535 984 - - - U16 4
Contains 100 parameter numbers index 300 - 399.
Index:
See r0980
Note:
See r0980
r0984[0...99]
List of available parame-
ter numbers
0 - 65535 985 - - - U16 4
Contains 100 parameter numbers index 400 - 499.
Index:
See r0980
Note:
See r0980
r0985[0...99]
List of available parame-
ter numbers
0 - 65535 986 - - - U16 4
Contains 100 parameter numbers index 500 - 599.
Index:
See r0980
Note:
See r0980