Technical specifications
SINAMICS V20 Converter
352 Operating Instructions, 10/2019, A5E34559884-012
Directives and standards
European Low Voltage Directive
The SINAMICS V20 product series and SINAMICS V20 Smart Access comply with the require-
ments of the Low Voltage Directive 2006/95/EC as amended by Directive 98/68/EEC. The units
are certified for compliance with the following standards:
EN 61800-5-1 — Semiconductor converters – General requirements and line commutated con-
When installed according to the recommendations described in this manual, the SINAMICS V20
and SINAMICS V20 Smart Access fulfill all requirements of the EMC Directive as defined by the
EMC Product Standard for Power Drive Systems EN 61800-3.
SINAMICS V20 Smart Access complies with the following requirements of Radio Equipment Di-
rective (RED) 2014/53/EU:
• Article 3(1)(a) Health and Safety (EN 60950-1, EN 62479)
• Article 3(1)(b) EMC (EN 301 489-1, EN 301 489-17)
• Article 3(2) Spectrum (EN 300 328)
The converter fulfills the requirements of Directive 2011/65/EU relating to the restriction of the use
of certain hazardous substances in electrical and electronic devices (RoHS).
The CE Declaration of Conformity is held on file available to the competent authorities at the fol-
lowing address:
Siemens AG
Digital Industries
Motion Control
Frauenauracher Straße 80
DE-91056 Erlangen
The SINAMICS V20 product series has been examined and certified by Underwriters Laboratories
(UL) to standards UL508C/UL61800-5-1 and CSA C22.2 NO-14-10.
The SINAMICS V20 product series complies with the appropriate RCM standard.
The SINAMICS V20 product series complies with the appropriate EAC standard.
To Next Page
Loading...
