Options and spare parts
B.1 Options
SINAMICS V20 Converter
360 Operating Instructions, 10/2019, A5E34559884-012
en the converters you desire to install include FSAA and/or FSAB converters and you
want to install FSAA and/or FSAB
converters side by side, to make sure that there is
sufficient space to fit the parameter loader to the FSAA/FSAB converter, install all av
ailable
FSAA converters to the farthest right, followed by all available FSAB converters and then all
other frame siz
es. There are no additional mounting sequence requirements for converters
other than FSAA and FSAB.
Recommended SD card
Article number: 6SL3054-4AG00-2AA0
Using memory cards from other manufacturers
SD card requirement:
● Supported file format: FAT16 and FAT 32
● Maximum card capacity: 32 GB
● Minimum card space for parameter transfer: 8 KB
Note
You use memory cards from other manufacturers at
your own risk. Depending on the
card manufacturer, not all functions are supported (for example, download).
Methods to power on the converter
Use one of the following methods to power on the converter for downloading/uploading
parameters:
● Power on from the mains supply.
● Power on from the built-in battery power supply. Press the power button on the
Parameter Loader and the converter is powered on.
● Power on from an external DC 5 V power supply that is connected to the Parameter
Loader. Press the power button on the Parameter Loader and the converter is powered
on.
Transferring data from converter to SD card
1. Fit the option module to the converter.
2. Power on the converter.
3. Insert the card into the option module.
4. Set P0003 (user access level) = 3.
5. Set P0010 (commissioning parameter) = 30.
To Next Page
Loading...
