Options and spare parts
B.1 Options
SINAMICS V20 Converter
372 Operating Instructions, 10/2019, A5E34559884-012
Installation
For three phase AC 400 V converters FSA to FSD and single phase AC 230 V converters
FSAC to FSC
The resistors can be installed in a vertical or horizontal position and secured to a heat
resistant surface. The required minimum clearance distances are shown below:
For single phase AC 230 V converters FSAA to FSAB and three phase AC 400 V converter
FSE
The resistors must be installed in a vertical position and secured to a heat resistant surface.
At least 100 mm must be left above, below and to the side of the resistor to allow an
unimpeded airflow.
To Next Page
Loading...
