Commissioning via the built-in BOP
5.1 The built-in Basic Operator Panel (BOP)
SINAMICS V20 Converter
58 Operating Instructions, 10/2019, A5E34559884-012
Normal editing of parameters
or for longer than two seconds to quickly increase or decrease the
er numbers or indexes is only possible in the parameter menu.
This editing method is best suited when small changes are required to parameter numbers,
indexes, or values.
● To increase or decrease the parameter number, index, or value, press
or for less
than two seconds.
● To quickly increase or decrease the parameter number, index, or value, press
or
for longer than two seconds.
● To confirm the setting, press
.
● To cancel the setting, press
.
Example:
Editing parameter values
Digit-by-digit editing
-by-digit editing of parameter numbers or indexes is only possible in the parameter
To Next Page
Loading...
