Siemens SINAMICS V20

Commissioning via the built-in BOP
5.6 Function commissioning
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
85
● High/low overload (HO/LO) modes (Page 136) (P0205)
A new parameter P0205 is added to enable the HO/LO selection for heavy/low load
applications.
● Imax control (Page 105) (P1340 to P1346)
● JOG mode operation (Page 88) (P1055 to P1061)
● List of modified parameters (P0004)
A new value is added to parameter P0004 to enable the parameter filter which allows you
to view the modified parameters.
● MODBUS parity/stop bit selection (P2034, P2035)
New parameters P2034 and P2035 are added to enable MODBUS parity/stop bit
selection.
● Motor blocking, load missing, belt failure detection (Page 108) (P2177 to r2198)
● Motor brake controls (Page 94) (holding brake, DC brake, compound brake and dynamic
brake) (P1215 to P1237)
● Motor frequency display scaling (P0511, r0512)
● Motor protection with PTC sensor (Page 116) (P610)
● Motor staging (Page 127) (P2370 to P2380)
● Motorized potentiometer (MOP) mode selection (P1031 to r1050)
● ON/OFF2 function for digital inputs (P0701)
A new value is added to parameter P0701 to run the motor with the ON command or
cancel the converter pulses with the OFF2 command.
● Parameter cloning (Page 357) (P0802 to P0804, P8458)
● PID controller (Page 92) (P2200 to P2355)
● Pre-configured connection macros and application macros (P0507, P0717) (see also
"Setting connection macros (Page 66)" and "Setting application macros (Page 77)".)
● Programmable V/f coordinates (P1320 to P1333)
● Protection of user-defined parameters (P0011, P0012, P0013)
● Skip frequency and resonance damping (P1091 to P1101, P1338)
● Slip compensation (P1334 to P1338)
● Super torque mode (Page 109) (P3350 to P3356)
● Text menu display (P8553) (see also "Setting motor data (Page 64)" and "Setting
common parameters (Page 79)".)
● User access level control (P0003)
● USS/MODBUS communication on RS485 (P2010 to P2037) (Page 175)
● Various stop mode selection (Page 86) (P0840 to P0886)
● Wobble function (Page 126) (P2940 to r2955)