Siemens SINEMA Remote Connect - Creating Node Groups

Configuring with Web Based Management
4.7 Remote connections
SINEMA Remote Connect - Server
Operating Instructions, 11/2017, C79000-G8976-C383-04
75
Manage address spaces
On the "OpenVPN" and "IPsec" tabs you can make the following settings for the address
spaces:
Box
Meaning
Start IP address
Start address of the address space.
Network mask The network mask belonging to the address space.
End IP address End address of the address space
The address space is limited by the start address and the network mask.
The end address must be within this range.
Use (assigned IPs / of
total)
The following is displayed:
• Number of available IP addresses and
• how many of these IP addresses are assigned.
Activate the network
address space
When enabled the device can be assigned a fixed IP address from the
address space.
Fixed IP protocol Only with OpenVPN:
• TCP: Applies to OpenVPN connections via TCP
• UDP: Applies to OpenVPN connections via UDP
Location of the fixed IP
address space:
• First: The fixed IP addresses are from the starting area of the address
space. The first IP address is reserved for the SINEMA RC Server.
The first fixed IP address is always the second IP
address after the start
IP address.
• Last: The fixed IP addresses are from the end area of the address
space. The last fixed IP address is always the end IP address.
Length of the fixed IP
address space:
Number of fixed IP addresses
4.7.3
Creating node groups
Users and devices can be put together in participant groups. A user or a device can be
assigned to more than one participant group. You also specify whether the communication
between the participants of an individual group is permitted or forbidden.
Once the participant groups have been created, you can define communication relations
between the groups (see section "Communication relations between participant groups
(Page 77)").
Requirement for creating participant groups
● The user has been assigned the right "Manage remote connections".